Suzuki Alto Forum in UAE

The new Suzuki Alto stalls when the air conditioning is turned on while idling in the summer.

Hey guys, my 2014 Alto's coolant temperature doesn't go above 80 degrees. Is this normal? Should I replace the thermostat? Which one is better, the original or from Tenpu?

What type of transmission oil is used for the Changan Suzuki Alto?

What type of transmission oil is used in the Changan Suzuki Alto? What is the specification?

Where is the air conditioning inspection hole located on the Changan Suzuki Alto?

Does your Alto automatically return to the center when you turn the steering wheel?

When starting a cold car, the RPM goes up to 2000 and then drops to 1500 but doesn't go any lower. The high idle speed is causing high fuel consumption, 20 liters for 300 kilometers! The idle speed is too high, and so is the fuel consumption. Can any experts provide a solution? 🙏

What causes a jerking sensation when gently pressing the accelerator?

Is the manual Alto manufactured in May 2014 a 2013 model or a 2015 model?

Hey car enthusiasts, my 2011 manual Alto has done over 70,000 kilometers and needs new front brake pads. Could you recommend a good quality brake pad for me to check out? Thanks!

Hey folks, when I brake suddenly in my Alto, there's a clunking sound, feels like it's locking up or something. Not really sure though. Anyone know what's going on?

The sound of rustling near the throttle belt on a 10-year-old Alto could be due to several reasons. It might be caused by a worn-out or loose belt, debris stuck in the belt area, or possibly an issue with the belt tensioner. It would be best to have it inspected by a professional to determine the exact cause.

How can I fix the issue of the engine noise being very loud when starting the Alto 1.0 when it's cold? The sound normalizes once the water temperature reaches 20 degrees.

Is the engine oil for the 2013 Alto 5W-30 or 0W-20?

After upgrading the central control screen, the car's audio sometimes works fine, sometimes only the right loudspeaker works, and sometimes there's no sound at all. What's going on?